Getting rid of the unknown fastfat device

From The IT Community
Jump to: navigation, search




Sometimes when you image a new PC you have an unknown device with no hardware id. When you delete this device it never shows up again. Most of the times it is the "Legacy FastFat" device.

To get rid of it, simply write an cmd file with the following:

reg delete HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Enum\Root\LEGACY_FASTFAT /f

Execute this cmd once after the device detection and you are good to go.

This is especially important rolling out images using SCCM.



Was this article helpful? Then please donate to keep The IT Community alive...

If you found this article helpful please share it, comment and help others by writing your own article.






Translate this page:




Articles found in the same category:
(max. 20 shown)